Complete Needles
my needles on my sewing machine?
Ok Im a beginner at this so bare with me please. I threaded the bobbin and have moved to try the machine on some tissues. So I'm going to sew with her and she did ok for a few seconds then it makes that noise and suddenly comes to a stop Complete and I noticed something flew thereof;. Well, he was part of the needle i darn good thing because it fell He was flying pretty darn fast. In any case I've been putting another needle and began again. A few seconds later he did the same thing except the needle didn't break this time. But I couldnt seem to get the needle loss and after several attempts I had to remove the forceps and cut the needle in half, dropping machine that wasn't for nothing. if Im at a loss here, I do not understand why this happens. can some help if Thank you please
On my machine, there is a screw behind the needle holder. You loosen the screw to remove the needle. When you replace the needle, you should know there is a front-side of the needle and a back-side of the needle. The needle is flat on one side. On my machine, it is the reverse side. It is possible that you just put the needle back. In addition, do not pull the fabric as it moves through the machine. The sewing machine will pull the fabric through a correct level. If you try using the Yank, you spoil the moment and break the needle. Good luck!
